GTCO 2500 Series - Users Guide 3/3 - Manual (Page 19)

2500 Series 19
Digitizing Commands
The following commands are those you might use while digitizing. They include changing
operating modes, data rate and resolution. Moving the origin, making active windows and
using the margin area are explained here.
Commands may interact with others. Tablet resolution affects the increment; baud rate,
data rate, prompting and operating mode interact. Interactions are explained under one
command. The other affected commands will refer you to the explanation.
Changing the Operating Mode
The operating modes may be changed by command from the host, cursor or menu. The
power-on default mode is controlled by the switch settings. The table below lists the
commands for each mode from individual sources. The cursor can only change to
Increment Track mode, of the possible Increment modes.
Operating Mode Commands