GTCO 2500 Series - Users Guide 3/3 - Manual (Page 6)

2500 Series 6
The command will take effect as soon as the Carriage Return block is picked.
NOTE: Picking the [ESC] [%] blocks from the ASCII portion of the menu will not activate any
commands. The command prefix for the menu commands is included in the function code
block represented by [a] and cannot be changed.
Enabling and Disabling Command Sources
The 2500 tablet can accept commands from the host, 16-button cursor, menu or soft
switches. The command sources may be disabled if they interfere with the operation of
the tablet.
The 2000 and 9100 compatible host commands may only be enabled and disabled by the
soft switches.
The 16-button cursor commands may be enabled and disabled by the host commands,
menu commands or soft switch settings. It may disable itself.
The menu may be enabled and disabled by host or soft switch commands. It may disable
itself.
The software switches may be enabled or disabled by a host or menu command. They will
also be enabled by powering the tablet off and on, or pressing the reset button.
Command Source Control Commands
Set Command Prefix
Set Command Prefix changes the default prefix from ESC % to one of your choice. The new
prefiex may be from one to three characters in length; it may use any ASCII characters
except BACKSPACE (08 HEX), CARRIAGE RETURN (0D HEX), RUBOUT (or DEL) (FF HEX) and @
(40 HEX). The new prefix will take effect immediately upon entering the command; the
default prefix ESC % will immediately cease to function.
Host = ESC % S b1 (b2) (b3) CR
Menu = [SET COMD CHAR] [b1] ([b2]) ([b3]) [CR]