GTCO 2500 Series - Users Guide 3/3 - Manual (Page 28)

2500 Series 28
If you have changed a parameter from its soft switch setting by using a host or menu
command, it will NOT be saved by the command. The tablet does not change the soft
switches as commands from the menu or host. It will change them in response to the
Recall Baseline and Recall Factory Settings switches of Bank 7.
Erase Current Settings from Memory
The current settings may be cleared from the memory. Writing a new set of parameters
replaces the old settings with new ones. This command erases the memory, leaving no
stored parameters.
Host = ESC % V E CR
Menu = [SYSTEM FUNC 1] [E] [CR]