GTCO 2500 Series - Users Guide 3/3 - Manual (Page 7)

2500 Series 7
Where:
b1
b2
b3 First command prefix character
Second, optional, command prefix character
Third, optional, command prefix character
EXAMPLE:
To change the command prefix to the characters * $ X, enter:
Host = ESC % S * $ X CR
Menu = [SET COMD CHAR] [*] [$] [X] [CR]
NOTE: It’s not recommended to use a command prefix that can be accidentally entered if
you bump the keyboard. Use keys that are on opposite ends of the keyboard or a prefix
with an ESC or SHIFT.
Tablet Reset
This command has the same effect as powering the digitizer off and on. The digitizer
reverts to the default operating settings determined by the soft switches. Any commands
stored for power-up use are invoked.
The tablet may also be reset by pressing the reset button located between the transducer
and output ports.
Host = ESC % V R CR
Menu = [SYSTEM FUNC 2] [R] [CR]
Enable/Disable Bank and Select
This command disables or enables the BANK and SELECT blocks. The soft switches will not
be accessible if the blocks are disabled, to prevent them from being altered by the
operator. Power-on or reset cancels this command, enabling the BANK and SELECT blocks
of the user menu.
Host = ESC % V m (b) CR
Menu = [SYSTEM FUNC 2] [m] [b] [CR]