GTCO 2500 Series - Users Guide 3/3 - Manual (Page 8)

2500 Series 8
Where b can equal 0 or 1 or no entry:
If b = 0
If b = 1
If no b is entered BANK and SELECT blocks are enabled.
BANK and SELECT blocks are disabled.
The condition toggles.
Menu – Locate, Erase or Restore
The optional menu is never enabled at power-up. You must enable it, specifying its
location. Once the menu has been enabled, you may use the erase and restore commands
to make it appear and disappear from the tablet surface. The menu will reappear where it
was when you erased it; the Mylar overlay may be left in this position, used for the menu
when needed and ignored when not required.
The default menu position is at the lower left corner of the active area. If you enable the
menu without specifying a location, it will appear here.
Host = ESC % V b CR (dpoint)
Menu = [SYSTEM FUNC 2] [b] [CR] [dpoint]
Where b can equal L, M or N.
If b = L, the Menu will be enabled. Its lower left corner will be located under the first point
digitized after the CR has been entered. The bottom edge of the overlay must be aligned
with the X-axis of the tablet and the menu must be right side up with respect to the tablet
logo. Although you cannot enter this command from the menu to enable it, the command
may be used to move the menu to a new location once it has been enabled.
If b = M, the Large Menu will be temporarily erased. The menu region stops sending
commands and begins to output position data. You may digitize past the overlay.
If b = N, the Large Menu will be restored at its previous position.
NOTE: The menu may erase itself, but the command to restore the menu must come from
the host or soft switches.