GTCO Roll-Up II - Users Guide - Manual (Page 25)

Roll-Up II 25
Roll-Up II Tones
The Roll-Up II produces an “alarm” in the form of audio tones to inform the user of various
events. The table below describes the kinds of tones you may hear while operating the
digitizer.
Table 3: Roll-Up II Tones
NOTE: You might also hear tones produced by the Roll-Up II which are sent by the
application program. (Programs can send commands to the digitizer to turn the audio tone
generator on and off.) If you hear tones during digitizing and they do not correspond to
tones listed in the table above, they are produced by the application program.
Troubleshooting Guide
As with any computer peripheral, Roll-Up II problems sometimes do occur. This
troubleshooting guide provides clear instructions for finding and solving all common Roll-
Up II issues. In a majority of cases, you will be able to quickly resolve the problem yourself
by following the below steps.
1. Install properly first.
This troubleshooting guide assumes you have already correctly installed Roll-Up II
according to the detailed instructions in the Installing the Roll-Up II section. If you
have not followed the step-by-step instructions in that section, do so now.