GTCO Roll-Up II - Users Guide - Manual (Page 8)

Roll-Up II 8
Configuring for Specific Application Programs
To configure Roll-Up II for use with specific application programs:
1. In Table 1, find the application program being used with Roll-Up II. Note the
corresponding SuperSet Code.
 If the application program is not listed in Table 1, find the configuration
settings that apply to the application program in Table 2 and use that
SuperSet Code.
 If an appropriate SuperSet Code is not listed in Table 2, then use the Custom
Configuration Menu to set up Roll-Up II.
2. Select on the SuperSet Menu and then choose the two digits of the SuperSet
code for the application program.
3. You will hear four short tones after a successful menu configuration. An example of
configuring for a specific application program follows.