GTCO Roll-Up II - Users Guide User Manual
Page 61
Roll-Up II 61
Line Incremental Mode
In Line Incremental Mode, one coordinate is sent when the transducer is moved farther
than a preset increment and a transducer button is pressed. Default increment is 0.01”.
Output occurs only when the transducer is in the active area.
To select Line Incremental Mode:
Custom Configuration Menu:
GTCO Commands:
Select the “Line Incr” option under Mode.
Send command IC; to set a new increment
value, send command IV and at the prompt,
send three digits representing the new
increment in units of 0.001”.
Continuous Incremental Mode
In Continuous Incremental Mode, one coordinate is sent when the transducer is moved
farther than a preset increment or a transducer button is pressed or released. Default
increment is 0.01”. Output occurs only when the transducer is in the active area.
To select Continuous Incremental Mode:
Custom Configuration Menu:
GTCO Commands:
Select the “Cont Incr” option under Mode.
Send command CL; to set a new increment
value, send command IV and at the prompt,
send three digits representing the new
increment in units of 0.001”.
Remote Request Mode
In Remote Request Mode, one coordinate is sent when the Controller receives a Read
Current Coordinate command (CTRL-B).
To select Remote Request Mode:
Custom Configuration Menu:
GTCO Commands:
Not available.
Send command RM.