GTCO Roll-Up II - Users Guide - Manual (Page 6)

Roll-Up II 6
5. Connect the interface cable to the appropriate jack on the connector panel. (The
connector is keyed and will fit only the correct jack.)
6. Join the 9-pin connector of the interface cable to the serial port on the computer. If
necessary, use the 9- to 25-pin adapter to connect to a PC-compatible (DTE male)
port.
7. Orient the tablet (see Changing the Tablet’s Orientation section) as desired.
8. Use the SuperSet Menu to select the two-digit SuperSet Code (shown in Table 1) for
the application program.
 If the application program is not listed in Table 1, find the configuration
settings that apply to the application program in Table 2 and use that
SuperSet Code.
 If an appropriate SuperSet Code is not listed in Table 2, use the Custom
Configuration Menu to set up the Roll-Up II.
9. Configure your computer for use with Roll-Up II:
 Arrange the graphic application software to operate with the Roll-Up II. A
wide variety of application programs provide configuration information for
specific digitizers. If Roll-Up II digitizer is not listed, use the configuration for
GTCO Digi-Pad Type 5 or Type 5A (T5/T5A), CalComp 9100/9500 or
Summagraphics Microgrid III or ID Series.