GTCO Roll-Up II - Users Guide - Manual (Page 51)

Roll-Up II 51
To set up the GTCO/CalComp Binary Format:
Custom Configuration Menu:
1. Select GTCO Binary or CalComp Binary (under Output Format Options).
2. Choose the desired resolution (under Mode Options).
GTCO Commands:
1. Send command BI for Binary format.
2. Send command IN for English or command MT for metric measurements.
3. Send command HR for 1000 lpi/40 lpmm or command H1 for 2000 lpi/100 lpmm
resolution.
Summagraphics Binary Format
This eight-byte format is compatible with the Summagraphics 2000 lpi UIOF format. Table
5 shows the structure of this format at the bit level.
To set up the Summagraphics Binary Format:
Custom Configuration Menu:
1. Select Summa Binary (under Output Format Options).
2. Choose the desired resolution (under Mode Options).