GTCO Roll-Up II - Users Guide - Manual (Page 7)

Roll-Up II 7
 If necessary, install the appropriate digitizer driver(s) from the Digitizer Driver
Diskette supplied (AutoCAD, Windows and mouse drivers are included).
Insert the diskette into drive A or B. From the DOS prompt, type a:\install or
b:\install and follow the on-screen instructions.
NOTE: Install only the drivers necessary for Roll-Up II to work with the application software.
10. Begin digitizing.
Using the SuperSet Menu
Use the SuperSet Menu to:
 Change the tablet’s orientation
 Configure Roll-Up II for specific application programs
 Use the Custom Configuration Menu
 Control the alarm
When using the SuperSet Menu, a tone will sound when selecting
indicating a successful selection.
The number blocks through are active only after selecting .
Changing the Tablet’s Orientation
Roll-Up II allows the user to choose between two different tablet orientations: orient the
tablet with the housing on the right (factory default) or on the left.
To change the orientation of the tablet:
1. Turn the tablet to the desired orientation.
2. Relocate the origin by selecting the block on the lower SuperSet Menu. You
should hear four short tones when you do this.
NOTE: The orientation of the 20x24 Roll-Up II cannot be changed.