Intek RheoVac 950A - Manual (Page 36)

I:\OFFICE\WPMANUAL\RV950 Appendix B2.wpd March 1, 2006
-B3-
necessary. Note: The Windows installation disk may be needed as well as administrator
security rights.
a. Installing Client for Microsoft Networks: If Client for Microsoft Networks is not in the
list of “The following network components are installed,” then do the following:
i.
Click the Install button below the list.
ii. The Select Network Component Type dialog box will appear.
iii. Select Client from the list then click the Add button.
iv. Select Microsoft from the Manufacturers list.
v. Select Client for Microsoft Networks in the Network Client list.
vi. Click OK.
b. Installing NetBEUI: If the NetBEUI (with the Ethernet adapter identified on the same line
next to it) is not in the list of “The following network components are installed,” then do
the following:
i.
Click the Install button below the list.
ii. The ‘Select Network Component Type’ dialog box will appear.
iii. Select Protocol and click the Add button.
iv. The ‘Select Network Protocol’ dialog box will appear.
v. Select NetBEUI from the Network Protocol list.
vi. Click OK.
4. Networking with the RheoVac 950: If all of the items above are completed successfully, the
UIC or LAN computer should be able to network with the RheoVac 950. To search for the
RheoVac 950 from the UIC or LAN computer:
a. Open My Computer
b. Each RheoVac instrument is identified by a unique Network ID. The ID is “R” plus the
first five digits of the serial number found on the unit. (RheoVac Model 950 devices
purchased prior to August, 2003 may use the serial numbers or “RheoVac 950” as the
Network ID.)
c. Look for the Network ID of your RheoVac 950. If the expected Network ID (see previous
paragraph) does not show up in the list, then type in the appropriate Address line (either
‘\\RHEOVAC 950’ or ‘\\’ and the first five digits of the serial number) and click the Go
button. This may take several seconds and then a RHEOVAC folder will appear, which
is the hard drive of the RHEOVAC 950.
d. Open the RHEOVAC folder and then open the DATA folder. The \\Network ID\
RHEOVAC\DATA folder contains all the stored data. Use copy/paste functions (copy -
Ctrl C; paste - Ctrl V) to save the data files to the UIC or LAN computer.
B.4 WINDOWS XP OPERATING SYSTEM
1. Ethernet Cable:
a. UIC Connection: use CAT5 network crossover cable (supplied by Intek) to connect the
Ethernet port of the UIC to the Ethernet port on the RheoVac 950.
b. LAN Connection: use CAT5 straight high noise-immune Ethernet cable (not supplied)
with RJ45 plug to connect the Ethernet port of the LAN to the Ethernet port of the
RheoVac 950.
2. Workgroup Identification: Unless otherwise requested, the Workgroup identification for the
RheoVac 950 will be WORKGROUP. To check/set the workgroup name: Click the Start
button and select Control Panel. Right click on the System icon and select Open. Select
the Computer Name tab. Verify that Workgroup is WORKGROUP. Use the Change button
to type in a new Workgroup if needed.