Juniper Systems Mesa User Guide - Manual (Page 10)

10
Mesa Rugged Notepad Owner’s Manual
3. Use the installation card to push air bubbles out (it may
take a few days for air bubbles to get worked out).
4. Never use sharp objects to adjust or remove the screen
protector.
Charge the Battery Pack(s)
Install and charge the Li-Ion battery pack(s). The Mesa is
designed to use 1 or 2 battery packs. Using two battery packs
extends the operating time of the unit. Geo 3G models should
always use two battery packs.
Complete the following steps:
1. The battery compartments are located on the back of the
Mesa. Loosen the quarter turn latches holding the battery
compartment door(s) in place using a coin or similar object
(loosen them enough to slightly lift the door, making it
easier to grab). Remove the door(s).
Note: If you are using one battery, for the best ergonomics we
recommend you use battery compartment #1 on the bottom
designated for battery 1 as shown in the following graphic.