Juniper Systems Mesa User Guide - Manual (Page 26)

26
Mesa Rugged Notepad Owner’s Manual
Charging Errors
Charging errors are caused by the following:
„
Battery pack(s) is too hot to charge
„
Battery pack(s) is too cold to charge
„
Cannot charge for unknown reason
If you have a charging error, make sure the battery pack(s) is
inserted correctly, the battery door(s) is closed properly, and
you are within the charging temperature range.
LED Activity Indicators
There are LED activity indicators located underneath the
bottom row of buttons that indicate the following:
„
Red, solid: Waiting to boot/startup, finished charging (when
external power is applied)
„
Red, blinking: External power applied, charging
„
Green: Suspend and resume notification
„
Blue: Not shown unless programmed
The blue and green LEDs are user programmable through
application software.
SD Cards
The Mesa has a slot for an SD card located in battery
compartment 1 (for SD and SDHC memory cards only). To
insert or remove a card follow these steps:
1. Suspend or power off the Mesa if the only power source is
from a battery pack in battery compartment 1.
2. Loosen the screws to battery compartment 1 and remove
the door.
CAUTION: The Mesa is not totally sealed against water
and dust when battery doors are not installed and properly
latched.
3. Remove the battery pack.
!