Juniper Systems Mesa User Guide - Manual (Page 38)

38
Mesa Rugged Notepad Owner’s Manual
Resetting the Mesa
It can be helpful to reset the Mesa when it is unresponsive,
slow, or programs won’t launch. You may be asked to perform
a reset when an application is installed.
CAUTION: Be aware that during a reset, applications are
terminated and unsaved work may be lost.
Follow these steps to reset your Mesa:
1. Save your open files and close any running programs.
2. Press and hold the power button until the Power menu
appears.
3. Choose Reset.
You can also reset the Mesa by pressing the power button for
10 seconds or until the screen goes dark. After a few seconds,
the Mesa automatically turns on. This method is useful if your
Mesa locks up.
Powering Off and Powering On the Mesa
To preserve battery power, we recommend you power off the
Mesa if it will not be used for two weeks or longer.
CAUTION: Be aware that when the Mesa is powered off, it
closes all programs and powers down all system components
except for the real-time clock. Unlike suspend mode, the device
resets when it is powered on again. Any unsaved data is lost.
1. Save all open files and close any running programs.
2. Press and hold the power button until the Power menu
appears.
3. Tap Power Off. A warning dialog appears. Tap OK.
To power on your Mesa, press the power button.
Restoring the Mesa to its Factory State (Clean Boot)
Follow the steps below to restore user storage, settings, and
icons on your Mesa to their original factory defaults.
!
!