Juniper Systems Mesa User Guide - Manual (Page 98)

Installing the desktop base:
1. On the back of the dock near the bottom there are two
screw holes, one on the left and one on the right. Place
screws into these holes and screw them in half-way.
2. Slide the desktop base up so the screw slots on the back
slide onto the screws and tighten them.
3. On the front of the desktop base near the top, and the
front of the dock near the bottom are two small screw
holes, one on the left and one on the right. Align the holes,
place screws into the holes, screw them in all the way, and
tighten them. The desktop base is now ready to use.
Mesa Dock Vehicle Mount
The vehicle mount (optional mobile dock accessory) allows
the mobile dock to be used in a vehicle or in another mobile
mounting application. Two RAM Mount bases with 1.5” balls,
a double socket arm, four screws, and four 8-32 nuts are
included.
Note: Additional attachments are available for the vehicle kit from
National Products Inc. at www.ram-mount.com.
98
Mesa Rugged Notepad Owner’s Manual