Longshine LCS-8056C2 - Manual (Page 127)

Commands for Host-Processed Modems Reference Manual
100498E Conexant 4-17
+FPR - Fixed DTE Rate
This numeric extended-format parameter specifies the data rate at which the modem will
accept commands during on-line operation. It may be used to select operation at rates at
which the modem is not capable of automatically detecting the data rate being used by the
DTE. Specifying a value of 0 disables the function and allows operation only at rates
automatically detectable by the modem. The specified rate takes effect following the issuance
of any result code(s) associated with the current command line.
The <rate> specified does not apply in OnLine Data State if Normal Mode (Direct Mode) of
operation is selected.
Syntax
+FPR=<rate code>
Defined Values
<rate code> Specifies the DTE-modem interface operation rate in bits/s with a
rate code. The available rate codes are:
0 Automatic detection (default)
1 2400 bits/s (executes +IPR=2400)
2 4800 bits/s (executes +IPR=4800)
4 9600 bits/s (executes +IPR=9600)
8 19200 bits/s (executes +IPR=19200)
10 38400 bits/s (executes +IPR=38400)
18 57400 bits/s (executes +IPR=57400)
If unspecified or set to 0, automatic detection is selected and the
character format is also forced to autodetect, +ICF=0.
If the rate specified is not supported by the modem, an ERROR
result code will be returned.
Reporting Current or Selected Values
Command: +FPR?
Response: <rate code>
Example 1: 0 For automatic rate detection.
Example 2: 18 For 57600 bits/s.
Reporting Supported Range of Parameter Values
Command: +FPR=?
Response: (<rate code> range)
Example: (0,1,2,4,8,10,18)