Longshine LCS-8056C2 - Manual (Page 99)

Commands for Host-Processed Modems Reference Manual
100498E Conexant 3-77
S6 - Wait Time for Dial Tone Before Blind Dialing, or After “W” Dial Modifier
S6 sets one of two possible parameters:
1. Sets the length of time, in seconds, that the modem will wait before starting to dial after
going off-hook when blind dialing.
2. If enabled by country options in the INF file, S6 sets the length of time, in seconds, that
the modem will wait for dial tone when encountering a “W” dial modifier before
returning NO DIAL TONE result code.
The modem always pauses for a minimum of 2 seconds, even if the value of S6 is less than 2
seconds.
Range: 2-255 seconds
Default: 2
S7 - Wait Time For Carrier After Dial, For Silence, or For Dial Tone After “W” Dial
Modifier
S7 sets one of three possible parameters:
1. Sets the length of time, in seconds, that the modem will wait for carrier before hanging
up. The timer is started when the modem finishes dialing (originate), or after the billing
delay in answer mode. In originate mode, the timer is reset upon detection of answer tone
if allowed by country restrictions.
2. Sets the length of time, in seconds, that modem will wait for silence when encountering
the @ dial modifier before continuing with the next dial string parameter.
3. If enabled by country options in the INF file, S7 sets the length of time, in seconds, that
the modem will wait for dial tone when encountering a “W” dial modifier before
continuing with the next dial string parameter.
Range: 1-255 seconds
Default: 50
S8 - Pause Time For Dial Delay
S8 sets the time, in seconds, that the modem must pause when the “,” dial modifier is
encountered in the dial string.
Range: 0-255 seconds
Default: 2