Longshine LCS-8056C2 - Manual (Page 48)

Commands for Host-Processed Modems Reference Manual
3-26 Conexant 100498E
P Select pulse dialing: pulse dial the numbers that follow until a "T"
is encountered. Affects current and subsequent dialing. Some
countries prevent changing dialing modes after the first digit is
dialed.
T Select tone dialing: tone dial the numbers that follow until a "P" is
encountered. Affects current and subsequent dialing. Some
countries prevent changing dialing modes after the first digit is
dialed.
W Wait for dial tone: the modem will wait for dial tone before dialing
the digits following "W". If dial tone is not detected within the
time specified by S7 or S6, the modem will abort the rest of the
sequence, return on-hook, and generate an error message.
* The 'star' digit (tone dialing only).
# The 'gate' digit (tone dialing only).
+
!
Flash: the modem will go on-hook for a time defined by the value
of S29. Country requirements may limit the time imposed.
@ Wait for silence: the modem will wait for at least 5 seconds of
silence in the call progress frequency band before continuing with
the next dial string parameter. If the modem does not detect these 5
seconds of silence before the expiration of the call abort timer (S7),
the modem will terminate the call attempt with a NO ANSWER
message. If busy detection is enabled, the modem may terminate
the call with the BUSY result code. If answer tone arrives during
execution of this parameter, the modem will handshake.
$ Wait for credit card dialing tone before continuing with the dial
string. If the tone is not detected within the time specified by S7 or
S6, the modem will abort the rest of the sequence, return on-hook,
and generate an error message.
& Wait for credit card dialing tone before continuing with the dial
string. If the tone is not detected within the time specified by S7 or
S6, the modem will abort the rest of the sequence, return on-hook,
and generate an error message.
, Dial pause: the modem will pause for a time specified by S8 before
dialing the digits following ",".
; Return to command state. Added to the end of a dial string. This
causes the modem to return to the command state after it processes
the portion of the dial string preceding the ";". This allows the user
to issue additional commands while remaining off-hook. The
additional commands may be placed in the original command line
following the ";" and/or may be entered on subsequent command
lines. The modem will enter call progress only after an additional
dial command is issued without the ";" terminator. Use "H" to
abort the dial in progress, and go back on-hook.
^ Toggles calling tone enable/disable: applicable to current dial
attempt only.
( ) Ignored: may be used to format the dial string.
- Ignored: may be used to format the dial string.
<space> Ignored: may be used to format the dial string.