Longshine LCS-8056C2 - Manual (Page 36)

Commands for Host-Processed Modems Reference Manual
3-14 Conexant 100498E
X - Extended Result Codes
This command selects the subset of the result code messages used by the modem to inform
the DTE of the results of commands.
Blind dialing is enabled or disabled by country parameters. If the user wishes to enforce dial
tone detection, a "W" can be placed in the dial string (see D command). The information
below is based upon the default implementation of the X results table. Table 3-1 indicates the
messages which are enabled for each X value.
If the modem is in facsimile mode (+FCLASS=1, or 1.0), the only message sent to indicate a
connection is CONNECT without a speed indication.
Syntax
X<value>
Defined Values
<value> Decimal number corresponding to the selected option.
0 CONNECT result code is given upon entering online
data state. Dial tone and busy detection reporting are
disabled.
1 CONNECT <text> result code is given upon entering
online data state. Dial tone and busy detection
reporting are disabled.
2 CONNECT <text> result code is given upon entering
online data state. Dial tone detection reporting is
enabled, and busy detection reporting is disabled.
3 CONNECT <text> result code is given upon entering
online data state. Dial tone detection reporting is
disabled, and busy detection reporting is enabled.
4 CONNECT <text> result code is given upon entering
online data state. Dial tone and busy detection
reporting are both enabled. (Default.)
Result Codes
OK <value> = 0 to 4.
ERROR Otherwise.