Longshine LCS-8056C2 - Manual (Page 98)

Commands for Host-Processed Modems Reference Manual
3-76 Conexant 100498E
S2 - Escape Character
S2 holds the decimal value of the ASCII character used as the escape character. The default
value corresponds to an ASCII '+'. A value over 127 disables the escape process, i.e., no
escape character will be recognized.
Range: 0-255, ASCII decimal
Default: 43 (+)
S3 - Line Termination Character
S3 sets the decimal value of the command line and result code terminator character. Pertains
to asynchronous operation only.
Range: 0-127, ASCII decimal
Default: 13 (Carriage Return)
S4 - Response Formatting Character
S4 sets the decimal value of the character generated by the modem as part of the header,
trailer, and terminator for result codes and information text, along with the S3 parameter (see
the description of the V parameter for usage). If the value of S4 is changed in a command
line, the result code issued in response to that command line will use the new value of S4.
The Response Formatting character is output after the Line Termination character if verbose
result codes are used.
Range: 0-127, ASCII decimal
Default: 10 (Line Feed)
S5 - Command Line Editing Character
S5 s sets the decimal value of the character recognized by the modem as a request to delete
from the command line the immediately preceding character. The modem will not recognize
the Command Line Editing character if it is set to a value that is greater than 32 ASCII. This
character can be used to edit a command line. When the echo command is enabled, the
modem echoes back to the local DTE the Command Line Editing character, an ASCII space
character and a second Command Line Editing character; this means a total of three
characters are transmitted each time the modem processes the Command Line Editing
character.
Range: 0-32, ASCII decimal
Default: 8 (Backspace)