Longshine LCS-8056C2 - Manual (Page 50)

Commands for Host-Processed Modems Reference Manual
3-28 Conexant 100498E
H - Disconnect (Hang-Up)
This command initiates a hang up sequence. This command may not be available for some
countries due to PTT restrictions.
Syntax
H[<value>]
Defined Values
<value> Decimal number corresponding to the selected option.
0 The modem will release the line if the modem is
currently on-line.
1 If on-hook, the modem will go off-hook and remain
in command mode.
Result Codes
OK <value> = 0 or 1.
ERROR Otherwise.
O - Return to On-Line Data Mode
This command specifies that the modem will enter the on-line data mode from the on-line
command mode with or without a retrain. If in the off-line command mode when this
command is entered, the modem reports ERROR.
Syntax
O[<value>]
Defined Values
<value> Decimal number corresponding to the selected option.
0 Enters on-line data mode from the on-line command
mode without a retrain. Handling is determined by
the Call Establishment task. Generally, if a
connection exists, this command connects the DTE
back to the remote modem after an escape (+++).
1 Performs a retrain then enters on-line data mode from
the on-line command mode.
Result Codes
OK <value> = 0 or 1 and a connection exists.
ERROR Otherwise or no connection exists.