TeeJet Legacy 6000 Manual - Manual (Page 38)

Legacy 6000
98-05053 R2
33
Table 2-13: Primary Sensor Options
Application sensor Options
Liquid Flowmeter, Pressure digital, and Pressure analog
granular granular
Seeder/motor Shaft
Nh3 Flowmeter
injection injection
primary sensor settings
the Primary Sensors (Flowmeter, granular, injection, and Shaft) have the same
settings (refer to table 2-14 for descriptions). the two other Primary Sensors (Pres-
sure digital and Pressure analog) have initial settings as well as sub-settings. to
access the sub-settings, locate the two Sub-Settings softkeys on the right side of
the screen. use the two softkeys to toggle between the screens. Refer to table
2-15 for a description of the sub-settings. when the primary settings and param-
eters have been selected, press the Forward Arrow softkey to advance to the next
Channel Setup page.
Figure 2-28: Primary Sensor/Sub-Settings
Forward Arrow
softkey (F6)
Initial-Settings
softkey (F9)
Sub-Settings
softkey (F10)