TeeJet Legacy 6000 Manual - Manual (Page 57)

Chapter 3 - Product application Setup 52
Calibration Procedure
granular, Liquid, Nh3, and Seeder calibrations share the same basic calibration
steps (refer to Figure 3-6). each has the option of performing a Static or in-Field
calibration. Select the Calibration softkey from the ARM Launcher page to begin
the Calibration Procedure. Select the desired Calibration type using the Arrow keys
(distance/Speed, Liquid, granular, etc.), followed by the Forward Arrow softkey.
the Legacy 6000 will navigate the operator through the necessary procedures to
perform the calibration process.
Figure 3-5: Calibration Screen
NOTE: Injection Calibration must be completed prior to priming for the system
to prime properly.
Calibration
softkey
Arrow keys
Forward Arrow
softkey (F6)