TeeJet Legacy 6000 Manual - Manual (Page 8)

Legacy 6000
98-05053 R2
3
System Components
dual Control module
the dual Control module (dCm) performs the control function for the CaN Bus
and connects the actuator and up to 6 sensors to the system. Control outputs can
be bidirectional or Pulse width modulated (Pwm). one dCm is required for every
two products to be controlled.
Figure 1-1: Dual Control Module (DCM)
swath XL Lightbar
the Swath XL Lightbar is required for applications using guidance (recommended
for non-guidance uses). For non-guidance (data logging), the lightbar provides
area and rate feedback.
Figure 1-2: Swath XL Lightbar