TeeJet Legacy 6000 Manual - Manual (Page 53)

Chapter 3 - Product application Setup 48
StaRtiNg JoBS
Pressing the Bullseye softkey on the Main Launcher page will display the Job
page. if a PC Card is not being used and the Console Setup PC Card setting is
“No” (refer to ChaPteR 2 - CoNSoLe SetuP), a Job Name is not requested
(refer to ChaPteR 3 - No PCmCia CaRd SetuP). a PC Card is necessary to
issue job names and save files.
when jobs are created, a folder is created on the PC Card that is labeled with the
same name. All files related to the job (record, guideline, boundary, and map ob-
jects) are stored in the folder upon saving in aRm.
there are three methods for entering/selecting job names
New Job Creation
•
existing Job Selection
•
Job Creation Based on existing Jobs
•
Figure 3-1: Job Page
New Job Creation
to create a new job, press the Create Job softkey on the Job page. this will launch
the New Job Name page as illustrated in Figure 3-2.
Bullseye
softkey (F6)
Create Job
softkey (F2)