TeeJet Legacy 6000 Manual - Manual (Page 78)

Legacy 6000
98-05053 R2
73
Figure 3-28: Tilt Sensor System
once the tilt Sensor is installed and connected to the Legacy 6000, two initial
setup steps must be performed:
antenna height entry
•
Calibration (level) of the tilt sensor
•
to perform these steps, the vehicle should be situated on level ground.
Antenna height
to access antenna height, select the System Setup softkey from the Main Launch-
er page. Select the GPS Receiver Setup softkey. Select the “antenna height” op-
tion on the gPS Receiver Setup menu and press Enter.
System Setup
softkey (F1)
GPS Receiver
softkey (F5)
Enter button