TeeJet Legacy 6000 Manual - Manual (Page 59)

Chapter 3 - Product application Setup 54
Figure 3-7: Priming System
1. Calculate prime value. Calculate the prime value using the following
formula. the value should be entered during Channel Setup - drive type
injection (refer to ChaPteR 2 - dRiVe tyPe SettiNgS).
uS
( line diameter in inches/ 2 )2 x 3.1416 x line length in inches x 0.5541 = volume in fluid ounces
metric:
(line diameter in cm/2)2 x 3.1416 x line length in cm = volume in ml
2. system setup for priming. Select the Prime softkey from the aRm
Launcher page to display the % Prime page. the % Prime page has two
softkeys (Prime State and Reset Values to Zero). the Prime State soft-
key provides a detailed set of values for the priming process. this page is
used to monitor pump priming progress during priming. the Reset Values
to Zero softkey will reset Prime values to zero.
)NJECTION
0OINT
3UPPLY
4ANK
0RIMING
Prime
softkey
Prime State
softkey (F6)
Reset Values to
Zero softkey (F7)