TeeJet Legacy 6000 Manual - Manual (Page 69)

Chapter 3 - Product application Setup 64
Figure 3-18: CAN Switchbox
input Status module (iSm)
when using an input Status module (iSm) instead of a CaN Boom Switchbox, the
system uses existing boom switches in the cab. the system must contain a Switch
Function module (SFm) and a switch (Part # 78-00028) connected to the iSm
to engage and disengage auto boom capabilities. existing wiring from the in-cab
boom switches to the boom valves needs to be disconnected, and this function
assumed by the SFm.
Figure 3-19: ISM
For automatic section control using existing switches, use the following switch
settings:
auto Boom engage/disengage Switch set to “engage”
•
master Switch oN
•
active boom switches oN
•
!UTO "OOM
)MPLEMENT
3TATUS
'ROUND 3PEED
/VERRIDE
)3-
#ABLE


$# XXXX
0ART