SINGER 5805 - Manual (Page 72)

Twin needle
sewing
Optional accessory
Caution:
Make sure not to set a stitch width
wider than symbol (
) when twin
needle stitching.
Recommended settings
Stitch selection: Desired stitch
Needle position: I
Stitch width:
Stitch length: 2-5
Foot: General purpose (B)
Needle plate: General purpose (A)
Procedure
• Turn the machine off.
• Insert the twin needle with the flat side of
the shank toward the rear of the machine.
• Thread the machine as you normally would
for single needle stitching, and pass the
thread through the left eye of the twin
needle.
• Insert a second spool pin into the hole on
the top cover of the machine, as illustrated.
• Thread the machine in the usual way.
• Pass the thread through the remaining
points, making certain to omit the thread
guide just above the needle and pass
thread through right eye of needle.
• Draw both threads under the foot and back
along With the bobbin thread.
• Slowly lower the needle into the hole in the
needle plate by turning the hand wheel
toward you to make sure the needle clears
the plate.