Button holes, Adjustable cloth stitching guide – SINGER W3851 User Manual
Page 34
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BUTTON HOLES
Use Buttonholes foot. Set zigzag stitch dial to 2 to 2.0
position. Start sewing to be desired length and stop with
needle on the leftside, leaving needle in the cloth and give
fabric half a turn counter-clockwise. Raise needle and zigzag
stitch dial at 5 width. Hold fabric in its place and with
a few stitches, make bar. Take needle out of fabric and
place zigzag stitch dial back on previous number. Sew again
length of buttonhole, then move zigzag dial at 5 position
and make a few stitches to finish off. Cut Imttonhole open
with button hole cutters. In case you want to make very
strong buttonholes, it can be done by using a length of cord
and follow its procedure as sewing CORDING as previously
staled.
ADJUSTABLE CLOTH STITCHING GUIDE
HDGH; OF MA 1 K
i|
I
ci.OTH
nr
P
THUMB'
MA IF RIAL
DF
SCRF'W
With the aid of this guide the operator is able to sew as close
to the edge of the material as desired, and to keep the stitches
at a uniform distance from the edge.
1)
Attach cloth guide to bed of machine by means of thumb
screw which fit into the screw holes in the bed of the
machine.
2)
After having adjusted cloth guide to desired distance,
tighten thumb screws securely and commence sewing.
■ 3U