SINGER 631 - Manual (Page 26)

BUTTON» tOI.ES
da)
StiUiiing Procedure. Set Selector and stitdi width lev'er. Place work under the needle, aligning the
center marking of buttonhole with center .score line of foot.
To form side stitching, turn hand wdieel toward you so the needle enters fabric at point A. Tower foot
and stitch to end of marking. I.eave needle in fabric at point B, Uaiso foot, pivot work on needle. Toever
foot. Take one stitch w'itliout changing stitch width lever setting, bringing work to point C. Adjust to
stitdi width lever setting for bar tacks and take no less than six stitches. Stop at point O. Readjust to
stitdi widtli lever setting for side stitching. Complete to point P. Move to stitdi width lever setting for bar
tacks and duplicate tack previously made, ending at point V,
ГЛ
BUTTONUOUiS
Raised or Corded Buttonholes. Both No. 8 pearl
cotton and buttonhole twist make suitable filler
cords for raised buttonholes.
Place the spool of filier cord on the second spool
pill. Cany tiie cord througli tlio first thread guide',
straight down between tlie center and back tension
discs, into the large tliread guide and then tlirough
the eyelet on tlie Special Purpose Foot. Draw tlie
cord under and in back of the foot and proceed as
for regular buttonholes.
To secure stildiing move stitdi width lever to
No. 1 setting and take three stitches. Remove work,
draw thread.s to the underside, fasten and trim.
With sharp eiiibroiciery scissors cut opening for
button.
52