How to remove the face cover, Cleaning, Lubricating the machine – SINGER XL1 Quantum User Manual
Page 45: Remove, Face
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
‘ CAUTION: Be sure to disconnect the plug from the wall outlet before opening the cover.
How
To
Remove
The
Face
Cover
,'\i-
CAUTION: Contact the
dealer in your area for the
correct light bulb
replacement.
The power consumption of
the light is 5 watts.
Using the exclusive screwdriver, loosen Remove the lamp cover. Push the lamp upward and
the setscrew at the rear of the face
cover by about two turns, and pull the
cover off sideways.
turn in the direction of the
arrow.
Cleaning
Removing the lint and dust
Accumulation of lint or dust may cause
problems. Always keep your sewing
machine clean.
'> CAUTION: Be sure to disconnect the plug from the wall outlet before cleaning
and lubricating the machine.
and clean the area between the feed clean,
dog teeth and the slots in the throat
plate, using the brush furnished with the
machine.
Lubricating The Machine
Be sure to only use sewing machine oil on the machine.
This sewing machine uses special bearings, and requires no lubrication in normal use. However, if the machine is operated for an
extended period of time or if it has not been used for a long time, lubricate the points indicated by the arrows shown below.
1. Open the hook cover, remove the bobbin case, and
lubricate the hook.
2, Open the face cover, and lubricate the tops and bottoms
of the needle bar and the presser bar as indicated by the
arrows.
43