Removing the work, Creative embroidery, Removing the work creative embroidery – SINGER W1762 User Manual

Page 16

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image



Be sure to stop the machine when the thread take-up

lever and needle bar are located at the highest position.

Now raise the presser foot and draw the fabric back and

to the left, Fig. 21-A and B, and pass the threads over the

Pull down slightly, holding thread m both hands, so as

not to bend the needle.

Leave the ends of thread under the presser foot.


R. .vire zigzag presser foot and zigzag needle plate........ _are

in Place and control lever "25" (Fig. D is in the M Positiom

The satin stitch. Fig. 22,

which is really just a very short
zigzag stitch, and the basis for

Fig. 2

most embroidery, is obtained by setting the stitch length as
near 0 as possible without stopping the feeding action.

The width may be set anywhere from just past 0 to the

widest, 4.

Fig. 21-A

Fig. 21-B