SINGER W1762 - Manual (Page 8)

Fig. 3
SETTING THE NEEDLE
See Fig. 3. Raise the needle bar A to its
highest point, turning wheel toward you hari ^
^ Then loosen the needle clamp screw B and
the needle can be inserted into clamp C. Pi^
needle (flat side to righU in the needle cla p
and push it upward as tar as it will
needfe clamp hole, tightening the needle clamp
screw securely with a screw driver.
_
After changing needle make one cornplete ^^lution
of balance wheel by hand to be sure the needle .s in
the correct position.
G R O O V E D
SIDE
F L A T
s u r f a c e d
S I D E
HOW TO WIND THE BOBBIN
Turn the clntch tn the center oUhe Aand^”f eeF 4) toward you
to disengage the sewing ' ; pjg 51. Pass thread through
a hole on edge of bobbin and place
bobbin on spindle (B) of winder. Be
sure that the notch in the bobbin fits
over the small pm on the spmdle. Place
pulley (C ( against hand wheel by press­
ing lever (D ) and set machirie in mo­
tion, When the bobbin is fully wound,
the action of the winder stops auto^
matically. Remove from spindle and
cut off loose thread end used to start
winding. Before starting to sew again,
tighten clutch by turning it I°\obbin winding tension
If the bobbin winds unevenly,
disc (A) to the right or left bj loosening the sere
disc is in the proper position, tighten screw.