Replacing presser foot with shank, Attaching darning and embroidery foot (g), Attaching feed cover (f) – SINGER 9113 User Manual

Page 12

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

REPLACING PRESSER FOOT WITH SHANK

Presser feet with built-in shanks can be replaced as follows:

Turn machine off.

Raise needle and presser foot.

Loosen

presser

foot

screw

(1)

and

remove

presser

foot

with

shank

(2),

guiding it toward you and to the right.

To

replace

presser

foot

with

shank,

hook

shank

around

the

presser

bar

and tighten,presser foot screw.

ATTACHING DARNING AND EMBROIDERY FOOT (G)

(Not included on 10 stitch sewing machine. See page 35).

This foot permits better control of fabric when doing free motion work.

• Raise needle.

Remove presser foot with shank.

Guide

Darning

and

Embroidery

Foot

from back of needle, with holding fork (1)

around presser foot screw, and lifting

finger (2) above needle clamp.

Tighten presser foot screw with coin.

To remove, loosen screw; guide foot

back.

ATTACHING FEED COVER (F)

The feed cover keeps the feed from moving the fabric.

Raise needle and presser foot.

Open slide plate.

Slide feed cover on top of needle plate,

pressing tabs (1) and (2) into holes.

Close slide plate.

To remove, open slide plate and lift

front edge of cover; pull it away.

Advertising
This manual is related to the following products: