Multhstitch zig-zag, Mending a tear – SINGER 9113 User Manual
Page 26
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Position the hem under the presser
foot with the soft fold resting against
wall of the guide. Be sure the flange of
the guide is between the soft fold and
the top of the hem, as shown.
Lower
the
presser
foot
and
begin
sewing
making
certain
the
straight
stitches fall on the edge of the hem
and the zig-zag stitches just pierce
the soft fold of the work. Adjust stitch
width
if
necessary.
While
stitching,
guide the hem edge in a straight line
and feed the soft fold evenly against
the wall of the guide.
If layers of fabric are pinned together,
remove pins as you come to them. Do
not sew over pins.
MULThSTITCH ZIG-ZAG
|
Mending, overcasting, joining or reinforcing can ail be done using the Multi-Stitch
Zig-Zag.
MENDING A TEAR
• Trim ragged edges of tear.
• Cut a lining of fabric for reinforce
ment.
• Bring the edges of tear together and
baste lining to wrong side of fabric.
RECOMMENDED SETTINGS
Stitch Selection:
Multi-Stitch
Zig-Zag
Stitch Width:
' 1 1 ^ 0 ’
Stitch Length:
1 or lower
Foot:
Special Purpose (J)
Needle Plate:
General Purpose (A)
Place tear, right side up, under presser
foot.
Stitch over the line of the tear, short
ening stitch length at each end for
reinforcement.
Trim thread ends close to fabric.
If needed, sew over tear again.
Trim away lining close to stitching.