Inserting a wound bobbin – SINGER 9113 User Manual
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
INSERTING A WOUND BOBBIN
To insert a bobbin, follow the instructions below.
• Raise presser foot.
• Turn hand wheel toward you until needle
is in its highest position.
• Open slide plate and remove bobbin.
1. Pull 4" (10cm) of thread from replace
case, as shown.
Holding bobbin in place, guide thread
into notch (1), and then into notch (2).
Draw several inches of thread across
While holding thread on outside, close
• Follow directions for “Raising Bobbin
Thread” on page