M how to change threads, Chair, off and test sew, How to – SINGER 14U64A User Manual

Page 11: Change threads, Chain off and test sew

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

m How to change threads

When you wish to change the left needle

thread, right needle thread, left looper
thread or right looper thread with a different

thread, the following steps will make the
changing convenient.

(1) Cut the thread near the spool and tie

the end to the thread you wish to
change to as shown in figure at right.

Raise presser foot.

Note tension reference numbers.

Turn the tension dials down toward the
(-) mark until the dial stops and draw
the' thread out so that the tie knot of
the threads extend about 5cm (2
inches) from the presser foot. When
drawing needle thread through the
needle eye, stop the tie knot before the
needle eye. cut the thread and pass it
through the needle eye.

Return tension dials to reference num­

bers.

(

2

)

(

3

)

(

4

)

(

5

)

i^nor

4. Chair, off and test sew

i-------;

c? •

:■ :

«

j ■.

r

- - -

3^

S:XCER

^4. ;

When the machine is completely threaded,

turn the hand wheel toward you 2 or 3 turns

while holding the 4 threads applying a slight
tension as shown in figure at left.

After chaining off, make a test stitch on a

sample of your fabric so that you can adjust
the thread tensions correctly.

Thread cutter.

/

After completing the
seam, chdin off approx.

5cm (2 inches) as shown

in figure at left and cut
thread with the thread
cutter on the presser
foot.

Advertising
This manual is related to the following products: