Setting up the thread guide holder, Thread the :::cgh:::8 – SINGER 14U64A User Manual
Page 6
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Thread the :::cGh:::8
Setting up the thread guide holder
Extend the thread guide holder as far as possible and set
the thread guides so that they are located right above
the spool pins.
Place the thread on the spool stand as shown in the
figure at the left.
When using synthetic threads that easily spill off the cop
(cone), slip the anti-spill sleeve furnished with the
machine over the thread from the bottom of the cop
(cone) leaving the thread end hanging free at the top of
the anti-süiil sleeve as shown above.
When using a regular thread spool, fit the
spool cap supplied with the machine onto the
thread soooi as shown at left.