SINGER 14U64A User Manual
Page 9
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
(2) Thread left looper in sequence from @ to 0 (marked in yellow color). Cylinder cover must also be
removed when threading this part. (Refer to page 5 for cylinder cover removal).
Wh^e holding thread with finger,
pass It between the tension discs
and puh thread down to make
certain It is properly located In
between the tension discs.
Turn hand wheel toward you
until left looper is at left as far
as it will go and thread looper
thread hole (§) from left to
right. (Use tweezers provided in
your accessory set).
Turn hand wheel toward you until
the looper is at right as far as
it will go passing the thread under
the throat plate, then using the
tweezers, thread the looper thread
hole 0 from front to back. Draw
about 5cmi (2 inches) of thread
from thread hole.