Hcv7 to eojost stitch length, Hcvr to ae|ost overedge seam width, How to adjust stitch length – SINGER 14U64A User Manual

Page 14: How to adjust overedge seam width

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image


. Hcv


to Eojost Stitch length

The stitch length dial on this machine is pre-set to 3mm for
normal sewing condition. Since the adjustment can be made
easily, adjust the stitch length to 4mm when sewing heavy weight
fabrics such as quilting and to 2mm when sewing light weight
fabrics such as lining fabric, crepe, etc. and you will obtain ex­
cellent seams without puckerings.


. Hcvr to ae|ost overedge seam width

Overedge seam width of this machine is set to 3,5mm for normal sewing conditions, however it can be
increased up to 5mm for overedging heavy weight fabrics as instructed below,

(1) Before making the adjustment, be sure that the power line plug is disconnected from the wall re­


(2) Open the looper cover, (See page 5)

(3) Turn the hand wheel toward you, lower the movable knife as far as it will go and set it in the non­

operating position as shown in figure below.

(4) Remove the cylinder cover. (See page 5).

(5) Turn the overedge seam width adjustment knob and

with the graduations on the throat plate as a rule, adjust
to desired seam width.

(6) Replace the cylinder cover. (See page 5)
(7) Return the movable knife to its original position and

close the cover.

Note: Do not set the overedge seam width below 3.5mm

as this may cause the stationary knife to mterfere
with the throat plate.


This manual is related to the following products: