SINGER 14U64A - Manual (Page 17)

• The minimum overedge stitch width that can be obtain*
ed for relied hemming is approximately 1.5mm since the
cutting width cannot be set below 3.5mm.
♦ When using threads that spill easily; slip the anti-spill
net furnished with the m.achine over the thread from
the bottom of the cone and place it on the spool stand
so as the bottom of the net folds inside the cone.
9. Free arm sewmz vrerki
s .inss
Use seam guide lines on looper cover to measure seam allow­
ances.
Thick line on extreme right is 5/8 inch from center of right
needle. Other lines are 1/8 inch apart.