Threading the machine – SINGER 6110 User Manual

Page 14

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

threading the machine

Raise the presser foot to release tension

discs and make sure needle and take-up

lever are in highest position.

Place spool pin felt from accessories over

spool pin, and place spool of thread on

spool pin over feit, with spool thread re­

taining slit A on top.

• Keep right hand on spool of thread to hold

firmly in place while threading machine.

• Snap thread into upper thread guide 1.

• Pass thread through point 2.

» Thread the needle thread tension 3. Slide

thread over metal plate into tension discs.

Lead thread under needle thread tension

and through tension wire by firmly pulling
thread straight up.

• Puii thread to right behind point 2 guiding

thread up toward take-up lever.

• Pass thread through points 4 to 6 as shown.;

• Thread needle from front to back and draw

about 10 cm (4 inches) of thread through

eye of needle.

J3

Advertising