Choosing and changing accessories, Changing the needle, Changing presser feet snap-on presser feet – SINGER 6110 User Manual
Page 5: To remove and replace foot
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
choosing and changing accessories
CHANGING THE NEEDLE
Raise needle to its highest point by turning
the hand wheel
clamp screw A and remove the needle.
Insert new needle up into clamp B as far
as it will go. with the fiat side of the needle
to the back.
« Tighten needie clamp screw.
Hat Side to Back
CHANGING PRESSER FEET
Snap-on Presser Feet
The presser feet furnished with your machine Raise needle to highest position by turning the
snap on and off a common shank.
Raise presser foot.
To Remove and Replace Foot
la. Press toe of pressor foot upward as far as 1b. Then snap down to remove,
it will go.
;2. Centre the new presser foot under the shank 3. Press presser foot screw down
lower the pressor foot lifter
so that foot snaps into place,
the shank fits over the presser foot pin.