Adjusting width of the design, Adjusting stitch placement – SINGER 6110 User Manual
Page 26
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SELECTING A PATTERN GROUP
Before moving pattern group selector, make
sure needle is above fabric.
When you rotate the pattern group selector,
one of five different groups of stitch pattern is
available to you.
Slide stitch width selector to | , then rotate
the pattern group selector as required, until
the number of the desired group of two stitches
is positioned under the T symbol above the
selector.
MiJ’
V.
ADJUSTING WIDTH OF THE DESIGN
Before moving stitch width selector, always
raise needle above fabric.
To produce a stitch pattern, th^ stitch width
selector must be moved from | toward the
right. The further you move the selector lever
toward the right, the wider your stitch will bo.
■
'V
Hi
;; :
■
.«.
[11:.li
Selector
ADJUSTING STITCH PLACEMENT
Before moving needle position selector, make
sure needle is above fabric.
Alt stitch patterns can be sewn in either left
X. , centre X . or right X needle position
Selector setting centre X is used most often.
A X left or X right setting is used to
piace narrow stitch patterns to the left or right
of the centre in decorative work.
?
Left
Centre
Right
25