Darning, To prepare singer 327k, 328k and 329k machines – SINGER 404K User Manual
Page 68
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Darning.
Anyone who can use a sewing machine can make darns in household
napery in a fraction of the time required for hand darning, and these will
be infinitely superior in appearance and will wear and wash better.
The only special fittings required for the work—all of which may be had
for the outlay of a few shillings—are a Darning or Embroidery Hoop, a small
plate to cover the feed, and a little Spring Presser to hold the material in
position while the needle is on its upward course.
%
%
'i
1
\ ""
1
§
1
1
- C -■•c,
'' ‘.i
c
F
ig
.
134.
To Prepare Singer 327K,
328K and 329K Machines
First
remove
the
presser
foot and the screw which fastens
it
to
the
presser
bar.
Throat
Plate Raising Plate should then
be
inserted
under
the
Throat
Plate,
as
shown
in
Fig.
135.
For
detailed
information
re
garding
this
and
the
darning
foot
for
these
machines,
see
instruction books.
F
ig
.
135.
To Prepare Singer 66K, 99K and 185K Machines for Darning.
First remove the presser foot and the screw which fastens it to the presser
bar. Then remove the needle clamp and in its place fix the Spring Darning
Presser No. 86496, or 121094. Before fixing to the needle bar, pass the needle
up through the centre of the small disc at the bottom of the Spring Presser.
Take care that the fiat side of the needle shank is towards the hand wheel,
and push it up into the clamp as far as it will go before finally tightening the
clamp screw.
68