Procedure – SINGER 404K User Manual
Page 69
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Pull out the shuttle cover slide far
enough to allow the feed cover plate
to be clipped over the needle plate, as
shown in Fig. 137 ; close the slide again
and make sure that the needle comes
down through the centre of the hole in
the feed cover plate and needle plate.
\
!
P
ig
. 136. T
hreading
for
D
arning
on
66K, 99K
and
135K M
achines
.
F
ig
.
137.
When
threading
the
66K,
99K
and
185K
Machines
for
darning,
care
must be taken that the thread is passed through the hole in the slack thread
regulator, as shown in Fig. 133. All other machines are threaded in the usual
way.
Attaching Embroidery Hoop Guide on 404 Machine for Darning.
F
ig
.
138.
Procedure—
• Remove presser foot.
• Elevate throat plate by setting
lever in centre (darning) position.
• Open slide plate.
Position
hoop
guide
over
throat
plate
with
two
extensions
under
throat plate, as shown above.
Slide hoop guide into place.
Close slide plate.
To Prepare Singer 15K110 and 201K Machines for Darning.
With Singer 15K110 and 201K Machines Spring Darning Foot No. 121094
should be used, but no Feed Cover Plate is required, as . an ingenious
arrangement provides for making the Feed inactive—see Instruction Book.
69