Preparing the machine for sewing, To increase pressure of, Rubber ring against hand – SINGER 404K User Manual
Page 8: Wheel, To wind the bobbin—machines 15k80, 15k110 and 201k
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
PREPARING THE MACHINE
FOR SEWING
Adjusting the Stop Motion Screw for
Winding Bobbins.
In preparing to sew with the machine,
first
see
that
the
bobbin
is
wound
with
thread of suitable size for the material to
be sewn (see page 11).
It
is
necessary
to
understand
the
stop
motion of the machine by which the hand
wheel can be released when winding bobbins,
thus permitting the winder to operate with
out
running
the
stitching
mechanism.
To
release
the
stop
motion,
hold
the
hand
wheel and turn the stop motion screw over towards you, as shown in Fig. 7.
F
ig
. 7. R
eleasing
the
S
top
M
otion
.
To Increase Pressure of
Rubber Ring against hand
wheel—
#
Press down winder until latch
(4) drops down and holds it.
Then loosen screw (5).
#
Push
back
upper
end
of
slotted plate (see inset, Fig. 8)
as far as it will go and at same
time
press
winder
against
hand wheel.
• Tighten screw (5).
• Raise latch to release winder.
To Wind the Bobbin—Machines 15K80, 15K110 and 201K.
Loosen stop motion screw.
Place
empty
bobbin
on
spindle.
Place spool of thread on spool
pin.
Thread
machine
as
shown
in
Fig. 8.
Hold end of thread and start
machine.
Break off end of thread after a
few coils have been wound on
bobbin
and
restart
machine
until
bobbin
is
filled
when
winder will stop automatical-
ly-
F
ig
. 8.