ADLINK aTCA-6250 - Manual (Page 79)

79
6.6 Boot Setup Screen
You can use this screen to specify options for the Boot configuration settings. Use
the up and down <Arrow> keys to select an item. Use the <+> and <-> keys to
change the value of the selected option. The settings are described in the following
pages. The screen is shown as the below.
Setup Prompt Timeout
It’s the number of seconds to wait for setup activation key. 65535 (0xFFFF) means
indefinite waiting. Use the <+> and <-> keys to change the value of this item.
Quiet Boot
This item allows system BIOS to show the boot up splash logo. When it is set to
“Enabled”, the logo that in system BIOS will be shown during display outputs.
GateA20 Active
Upon Request – GA20 can be disabled by using BIOS services. Always – do not
allow disabling GA20. This option is useful when any RT code is executed above
1MB.
Option ROM Messages
Set this option to enable for allowing system to display PCI devices’ option ROMs
during system boot up.
INT19 Trap Response